Traffic > Barriers > Gate Barrier
Gate Barrier

The Gate is one of the most popular blow moulded barriers. This superior blow moulded HDPE barrier offers superb quality at a low life cost.


Incredible strength and durability.
Free standing with 360° swivel feet.
Free from screws and rivets.
Stacks in 50mm (2 inch) with location (40 per pallet).
Moulded in orange as standard, but can be coloured to suit.
Coloured feet if desired.
A moulded lamp connector.
Barrier to barrier connection is quick and easy to use on uneven ground.
Manufactured in High Density Polyethylene.
Company identification can be embossed.


Conforms to requirements of BSEN8442
Reflectivity requirements of BSEN12899-1
Chapter 8 - The Traffic Signs Manual
Safety at Street Works & Road Works
   – A Code of Practice.
Traffic Signs Regulations & General Directions

Spec Sheet:



Wind Resistance

All temporary traffic barriers must be able to withstand three different classes of wind speeds with the use of a ballast. The standard BS 8442:2015 states the three classes as the following:

Class A: 26.3 m/s (58 mph)
Class B: 17.6 m/s (39 mph)
Class C: 8.7 m/s (19 mph)

The Gate Barrier system was tested under strict conditions at the Full Scale Wind Tunnel at Mira to determine at which wind speeds the barrier can withstand. Below are the results and guides as to the recommended ballast weight for each Wind Class:

Class C
Withstood up to 19.4 mph.
Recommended Ballast Weight: 0 kg
Class B
Withstood up to 42.3 mph.
Recommended Ballast Weight: 30 kg
Class A
Withstood up to 59.1 mph.
Recommended Ballast Weight: 90 kg
Road Rock
Withstood up to 42.3 mph.
Recommended Ballast Weight: 0 kg
Boxed with Road Rock
Withstood up to 59.4 mph.
Recommended Ballast Weight: 70 kg
Images are for representation purposes only.